LS Plot Request Properties
Change the longsection plot request on the sheet.
Sheet
Choose the sheet from the list.
Sheet X Origin
Enter the position on the sheet in mm - relative to the sheet origin.
Sheet Y Origin
Enter the position on the sheet in mm - relative to the sheet origin.
Longsection
Choose the longsection you want to insert onto the sheet.
Start Chainage
The longsection may be too long to fit on the sheet in one section.
You can plot any part of the section, enter the start and end chainage you want plotted.
End Chainage
Enter the end chainage of the section you want plotted.
Base Level
Choose the base level, or don’t touch this field to allow the program to automatically
choose the base level.
Horizontal Scale
Enter the required horizontal scale for the longsection display.
Vertical Scale
Enter the required vertical scale for the longsection display.
Titles
Tick this box to display the longsection name e.g. ‘Road 1’
Vertical Curves
Tick this box to display the vertical curves.
Grades
Tick this box to display the grades on the longsection.
Truncate 0s
Tick this box to truncate trailing zeros from numbers
Dogleg Lines
Tick this box to allow vertical lines to be offset or ‘dog legged’ where they are too close together.
Extra Lines - Design Surface Lines
You can request extra design surface lines to be drawn on the longsection by entering one or more point codes.
The points with this code on the cross section will be drawn (using the chainage and point design RL.
You can enter several point codes separated by semi-colons (;). e.g. 'ABC;DEF;GHI'.
All the points with point code ABC will be joined, the points with point code DEF will be joined and the points with code GHI will be joined.
Go There
Changes the display so that the requested longsection is displayed.
Display Parameters
Display the details of the drawing parameters.
General information and Frequently Asked Question.